BMW X3 Service & Repair Manual: Removing and installing/replacing oil level sensor for engine oil (N47 D20 O1)
IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .
Necessary preliminary tasks:
- Switch off ignition
- Remove front UNDERBODY PROTECTION .
- Drain ENGINE OIL .
Unlock connector (1) and remove.
Unscrew nuts.
Remove oil level sensor (2).
Installation note:
Clean sealing surface on oil sump.
Replace seal on oil level sensor.
An excessively low torque value will result in oil leaks.
An excessively high torque value will result in damage to the oil level sensor.
Top up engine oil.
NOTE: Check stored fault messages.
Delete fault memory.
Removing and installing/renewing oil level sensor for engine oil (N55)
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC
DISCHARGE (ESD PROTECTION) .
Necessary preliminary tasks:
Swit ...
Other materials:
BMW X3 Service & Repair Manual > Body repair instructions: Stamping vehicle identification number (needle stamping unit)
Read and comply with GENERAL INFORMATION.
The needle stamping system 360 - VRM - BMW is required to stamp the vehicle identification number.
Order number: 81 43 2 155 736
The needle stamping system 360 tool set comprises:
(1) Display
(2) Mains adapter
(3) Needle stamping unit
(4) Co ...
BMW X3 Owners Manual
BMW X3 Service & Repair Manual
