BMW X3 Service & Repair Manual: Heater with operation
BMW X3 Service & Repair Manual / HVAC / Heater with operation
- Installing servodrive
- Removing and installing (replacing) control panel for heating and air conditioning system
- Removing and installing/replacing actuator drive for central kinematics (a/c control)
- Removing and installing radio and a/c control panel
- Removing and installing/renewing heating unit
- Removing and installing/replacing actuator drive for fresh/recirculated air flap
- Removing and installing/replacing footwell temperature sensor
- Removing and installing/replacing heater/air conditioner blower
- Removing and installing/replacing sensor for automatic recirculated air control (auc)
- Removing and installing/replacing servodrive for blending flap (left)
- Removing and installing/replacing servodrive for blending flap (right)
- Removing and installing/replacing servodrive for defrosting flap (right)
- Removing and installing/replacing ventilation temperature sensor
- Replacing actuator drive for rear compartment flap
- Replacing actuator drive of ventilation flaps
- Replacing controller for heating and air conditioning system blower
- Replacing evaporator temperature sensor
- Replacing heat exchanger
- Replacing servodrive for blending flap
- Replacing servodrive for footwell flap (automatic a/c)
- Replacing the button caps of the heating and air conditioning system control panel
Safety information for working on vehicles with automatic engine start-stop
function (msa)
WARNING:
If the engine hood/bonnet contact is pulled upwards (workshop mode), the
information "switch closed" is output. The automatic engine start ...
Installing servodrive
Installation:
If necessary, align shaft of flap(s) to be actuated to position of servodrive to be installed.
OVERVIEW OF ACTUATOR DRIVES ON HEATER ...
Other materials:
BMW X3 Service & Repair Manual > Engine wiring loom: Replacing section of wiring harness for injectors (N47 D20 O1)
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE
(ESD PROTECTION) .
Necessary preliminary work:
Read out the fault memory of the DDE control unit.
Switch off ignition.
Disconnect BATTERY EARTH LEAD .
Remove INTAKE FILTER HOUSING .
Remove rear aco ...
BMW X3 Owners Manual
BMW X3 Service & Repair Manual
© 2017-2024 Copyright www.bmwx3tech.com - 0.0099