BMW X3 Service & Repair Manual: Removing and installing/replacing sensor for automatic recirculated air control (auc)

BMW X3 Service & Repair Manual / HVAC / Heater with operation / Removing and installing/replacing sensor for automatic recirculated air control (auc)

Necessary preliminary work:

  • REMOVING and installing/replacing right microfilter housing cover

Remove filter cover (1) in direction of arrow.

HVAC

Unfasten plug connection (2) and disconnect.

Unlock retaining tab (1) and remove AUC sensor.

HVAC

Installation note: Retaining tab (1) on AUC sensor (2) must not be damaged.

HVAC

    Removing and installing/replacing heater/air conditioner blower
    Necessary preliminary work: Remove TRIM FOR INSTRUMENT PANEL AT BOTTOM RIGHT Detach right footwell heating duct (1) in direction of arrow from ...

    Removing and installing/replacing servodrive for blending flap (left)
    Necessary preliminary work: Remove SUPPORT FOR DASHBOARD Release screws (1). Remove actuator drive (2). Unlock plug connection (3) and di ...

    Other materials:

    BMW X3 Service & Repair Manual > Propeller shaft: Spindle
    Spindle AM NOTE: (Spindle with rotary handle) NOTE: With synchronising key, transmission: All WASHER Washer Mechanical tool Replaced by: 83300491818 NOTE: (Extraction washer) For the constant velocity joint on the propeller shaft. Replaced by 26 1 110. (0 491 818) ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2022 Copyright www.bmwx3tech.com - 0.0756