BMW X3 Service & Repair Manual: Removing and installing/replacing ventilation temperature sensor

BMW X3 Service & Repair Manual / HVAC / Heater with operation / Removing and installing/replacing ventilation temperature sensor

Necessary preliminary work:

  • Remove DECORATIVE STRIP ON DASHBOARD IN MIDDLE

Pull temperature sensor (1) out of retaining lug (2).

Installation note: Make sure rubber ring is correctly seated.

HVAC

Disconnect plug connection (1) and remove temperature sensor (2).

HVAC

    Removing and installing/replacing servodrive for defrosting flap (right)
    Necessary preliminary work: Remove SUPPORT FOR DASHBOARD Release screws (1). Remove actuator drive (2). Release plug connection (3) and d ...

    Replacing actuator drive for rear compartment flap
    Necessary preliminary tasks: Remove RIGHT GLOVE BOX WITH HOUSING Release screws (1). Detach actuator drive for rear compartment flap (2) fro ...

    Other materials:

    BMW X3 Service & Repair Manual > Transmission: Extension housing, bearings, seal
    REPLACING OUTPUT FLANGE RADIAL SHAFT SEAL (GA8HP45Z) (AWD) Special tools required: 23 0 490 23 3 220 IMPORTANT: After completion of repair work, check TRANSMISSION OIL LEVEL . Use only the approved TRANSMISSION OIL . Failure to comply with this requirement will result in serious dam ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2024 Copyright www.bmwx3tech.com - 0.03