BMW X3 Service & Repair Manual: Replacing heat exchanger

Necessary preliminary work:

IMPORTANT: Before ordering spare parts, determine manufacturer of the installed heater!

Installation note:

Pipes are included in the repair kit! Release screws (1).

Slide rubber grommet (2) with foam seal forward slightly.

Carefully feed pipe holder (3) with pipes (4) past rubber grommet (2).

Installation note:

If necessary, replace rubber grommet (2) and/or foam seal.

Make sure rubber grommet (2) is fitted correctly on pipe holder (3).

HVAC

If necessary, remove coolant hose (2).

Release screws (3) and remove cover.

NOTE: Diesel version only:

Unfasten plug connection (1) and disconnect.

Withdraw electric auxiliary heater (4) in direction of arrow.

Remove heat exchanger (5) from heater/air conditioner (6).

HVAC

Necessary preliminary tasks: Remove TRIM FOR INSTRUMENT PANEL, BOTTOM LEFT Disconnect plug connection (1). Pull evaporator temperature senso ...

Necessary preliminary work: Remove SUPPORT FOR DASHBOARD Release screws (1). Detach actuator drive for stratification flap (2) from heating/ ...

BMW X3 Service & Repair Manual > Transmission in general: Removing and installing automatic transmission (GA8HP45Z) (N55)
Special tools required: 24 4 161 24 4 166 24 4 160 24 2 390 23 4 050 00 2 030 24 1 110 IMPORTANT: To prevent heavy damage to the engine block, the protruding thread of the transmission bolts absolutely must be checked for damage and corrosion before removal. If there are ...

BMW X3 Owners Manual