Necessary preliminary work:
Carefully pull rubber grommet (1) and foam seal (2) over pipes (3) and (4).
NOTE: If necessary, replace rubber grommet (1) and/or foam seal (2).
Release screws (5).
Unfasten plug connection (1) and disconnect.
Carefully remove seal (2) and all remnants.
Installation note:
Replace gasket (2).
Turn temperature sensor for cold-air distributor (3) in direction of arrow and detach in upwards direction.
Expose connecting cable (4) of temperature sensor for cold-air distributor (3) towards rear of heater/air conditioner (5).
Release screws (1).
Remove upper housing (2) of heater/air conditioner in direction of arrow.
Installation note: Make sure upper housing (2) is correctly seated on heater/air conditioner.
Pull evaporator (1) in direction of arrow out of lower housing (2) of heater/air conditioner.
Installation note: Make sure evaporator (1) is correctly seated in lower housing (2) of heater/air conditioner.
IMPORTANT: Do not bend radiator fins.
If necessary, clean or straighten radiator fins with slat comb.
BMW X3 Service & Repair Manual > Front axle gearbox: Removing and installing/replacing left or right output shaft
Special tools required:
31 5 110
NOTE:
If the wishbone is detached from the front axle support, it will be necessary to
carry out the wheel alignment procedure.
Necessary preliminary tasks:
Remove FRONT WHEEL .
Remove front UNDERBODY PROTECTION.
Remove ANTI-ROLL BAR LINK FROM ANTI ...