Special tools required:
NOTE: When replacing the rubber mount in the wishbone, a wheel alignment .
Necessary preliminary work:
Press rubber mount out with special tools 31 1 051 , 31 1 054 and 33 3 054 .
Installation note:
Keep rubber mount and bore in control arm clean and free from grease.
Press rubber mount in and out at chamfered side of wishbone bore hole.
Installation note: Protrusion (A) = 5.74 Â+- 0.3 mm.
After installation: Carry out wheel alignment procedure .
BMW X3 Service & Repair Manual > Driveline+Axles: With suspension
REMOVING AND INSTALLING/REPLACING REAR LEFT OR RIGHT COIL SPRING
Installation note:
1. All screws, nuts, bolts and hose clamps removed during the repair must be replaced.
2. Retaining elements on chassis and suspension and steering parts must be replaced.
IMPORTANT:
Both coil sp ...