BMW X3 Service & Repair Manual: Removing and installing/replacing control unit for vertical dynamic control
BMW X3 Service & Repair Manual / Suspension / Electronic damping force adjustment / Removing and installing/replacing control unit for vertical dynamic control
IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .
Necessary preliminary tasks:
- Remove ignition key.
- Disconnect BATTERY NEGATIVE CABLE .
- Remove FLAP IN LUGGAGE COMPARTMENT TRIM PANEL ON RIGHT .
Undo screw (1), release expanding rivets (2) and remove storage compartment.
Unscrew nuts (1).
Unlock connector (2) and remove.
Remove control unit.
After installation:
- Replacement only: Carry out PROGRAMMING/ENCODING .
- Start up the VDM with the aid of the diagnosis system.
- Replacement only: Carry out RIDE HEIGHT ADJUSTMENT.
Replacing left or right wheel speed accelerator sensor
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC
DISCHARGE (ESD PROTECTION) .
Disconnect plug connection (1) from a ...
Other materials:
BMW X3 Service & Repair Manual > Control arms and struts: Replacing an upper wishbone
IMPORTANT:
The wishbone must be installed with the opening (U-section) facing downward!
If the wishbone is bent, the screw connection between the control arm and wheel carrier
must be replaced.
Necessary preliminary work:
Remove REAR WHEEL .
Release left and right scr ...
BMW X3 Owners Manual
BMW X3 Service & Repair Manual
© 2017-2024 Copyright www.bmwx3tech.com - 0.01