IMPORTANT:
- The RADIAL SHAFT SEAL FOR THE OUTPUT SHAFT should be renewed every time the output shaft is removed and installed.
- The circlip of the output shaft must be replaced after re-installation.
NOTE: The procedure is described in PRESSING OUTPUT SHAFT OUT OF DRIVE FLANGE AND DRAWING IN.
After installation:
REMOVING AND INSTALLING/REPLACING LEFT OR RIGHT OUTPUT SHAFT
IMPORTANT:
- The RADIAL SHAFT SEAL FOR THE OUTPUT SHAFT should be renewed every time the output shaft is removed and installed.
- The circlip of the output shaft must be replaced after re-installation.
NOTE: The procedure is described in REMOVING AND INSTALLING STEERING STUB/WHEEL CARRIER.
After installation:
BMW X3 Service & Repair Manual > Master brake cylinder: Removing and installing/replacing tandem brake master cylinder for dsc
Necessary preliminary tasks:
Read and comply with GENERAL INFORMATION.
Remove EXPANSION TANK.
REMOVE left partition wall for units compartment.
After completing repair work, bleed BRAKE SYSTEM WITH DSC.
IMPORTANT:
Before beginning repair work, fully press the brake pedal several tim ...