WARNING: Danger of injury! Failure to comply with the following instructions may result in the vehicle slipping off the vehicle hoist and critically injuring other persons.
Load the luggage compartment with a minimum of 100 kg before lowering/removing the rear axle support. This prevents the vehicle from tilting or sliding off the vehicle hoist! When supporting components, make sure that:
IMPORTANT: Before lowering/removing rear axle support: Observe SAFETY INFORMATION for raising the vehicle In order to avoid damage to vehicle hoist, perform weight compensation on vehicle.
Necessary preliminary work:
Release RIDE HEIGHT SENSOR WITH JOINTED ROD ON REAR AXLE SUPPORT .
Release both ANTI-ROLL BAR LINKS AT ANTI-ROLL BAR.
Release both CAMBER ARMS ON REAR AXLE CARRIER.
Release both TOE LINKS ON REAR AXLE CARRIER.
Release both TRAILING ARMS ON REAR AXLE CARRIER.
Release both CONTROL ARMS ON REAR AXLE CARRIER.
Release both WISHBONES ON REAR AXLE CARRIER.
Remove both wheel carriers with output shaft, all arms, anti-roll bar link and brake disc.
Release ANTI-ROLL BAR.
Take rear axle support down from special tool with assistance of a 2nd person and set down on a suitable surface.
Installation note:
Use previous rear axle support as a template for modifying or replacing small parts.
After installation:
BMW X3 Service & Repair Manual > Rear axle: Synchronising key
Synchronising key AM
Storage Location
Y4
Synchronising key AM
NOTE: For ball bearing, inner
Synchronising key AM
Synchronising key AM
NOTE: (Thrust piece (for removing)) Deletion, only available via tool set
Storage Location
C53
SI number
01 18 05 (214)
Synchronising key AM
NOTE ...