IMPORTANT: If the camber arm is bent, the control arm/wheel carrier screw connection must be renewed.
NOTE: If the camber arm is renewed, the wheel alignment .
Necessary preliminary work:
Support wheel carrier with workshop jack! Mark position of eccentric adjustment washer to rear axle support to simplify subsequent adjustment of rear axle.
Release nut (1) and remove eccentric bolt.
Installation note:
Note insertion direction of eccentric screw.
Renew nut, eccentric bolt.
Tighten down screw connection in NORMAL POSITION .
Release nut (2) and remove screw.
Installation note:
Note direction of insertion of screw.
Replace screw and nut.
Release nut (3) and remove screw.
Installation note:
Note direction of insertion of bolts.
Replace screw and nut.
After installation:
BMW X3 Service & Repair Manual > Starter lead: Replacing safety battery terminal (sbk)
CAUTION: Observe safety regulations.
Investigate cause of triggering of safety battery terminal.
To do so, read out fault memory of airbag control unit. Note fault messages
stored in memory. Rectify faults. Then clear fault memory.
Use of safety battery terminal:
From model year 1998 in ...