IMPORTANT:
- The toe link must be installed with the opening (U-section) facing downward!
- If the toe link is bent, the control arm/wheel carrier screw connection must be renewed.
NOTE: If the toe link is detached from the rear axle support, it will be necessary to carry out the wheel alignment procedure .
Necessary preliminary work:
Open clips and remove cable for pulse generator.
Installation note:
Replace defective clamps.
Release screw (1).
Installation note:
Replace screw.
The toe link must be installed with the opening (U-section) facing downward! Tighten down screw connection in NORMAL POSITION .
Mark position of eccentric adjustment washer to rear axle support to simplify subsequent adjustment of rear axle.
Release nut (2) and remove screw.
Installation note:
Replace nut.
Tighten down screw connection in NORMAL POSITION .
Installation note: When installing, ensure that the tapered side of the bearing bush is connected first toward the wheel carrier.
After installation:
BMW X3 Service & Repair Manual > Engine wiring loom: Removing and installing/replacing engine sensor system wiring harness module 1 (N20, N26)
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC
DISCHARGE (ESD PROTECTION) .
Necessary preliminary tasks:
Read out the fault memory of the DME control unit.
Switch off ignition.
Remove INTAKE PLENUM .
Overview, engine sensor system wiring harness modu ...