IMPORTANT:
- The trailing arm must be installed with the opening (U-section) facing downward!
- If the trailing arm is bent, the control arm/wheel carrier screw connection must be renewed.
Necessary preliminary work:
Unscrew nuts (1).
Pull out bolt towards front.
Installation note:
Note direction of insertion of bolts.
Replace screw and nut.
Tighten down screw connection in NORMAL POSITION .
Slacken nut (2).
Move screws toward the rear.
Remove trailing arm (3) downward.
Installation note:
The trailing arm must be installed with the opening (U-section) facing downward! Note direction of insertion of screw.
Replace screw and nut.
Tighten down screw connection in NORMAL POSITION .
BMW X3 Owners Manual > Alarm system: Avoiding unintentional alarms
The tilt alarm sensor and interior motion sensor
can be switched off together, such as in
the following situations:
In automatic car washes.
In duplex garages.
During transport on trains carrying vehicles,
at sea or on a trailer.
With animals in the vehicle.
Switching off the tilt a ...