BMW X3 Service & Repair Manual: Replacing both rubber mounts for anti-roll bar mounting

BMW X3 Service & Repair Manual / Suspension / Stabilizer bar / Replacing both rubber mounts for anti-roll bar mounting

Necessary preliminary work:

Remove REAR WHEELS .

Release screws (1).

Pull off retaining bracket (2), open rubber mount (3) at slot and remove.

Installation note:

Keep retaining bracket (2), rubber mount (3) and anti-roll bar clean and free from oil and grease.

Clean rear anti-roll bar on both sides.

Suspension

Position rubber mount on rear anti-roll bar.

Mount retaining bracket (2) on rubber mount (3).

Push rubber mount with retaining bracket on rear anti-roll bar to installation position and screw tight.

Removing and installing/replacing rear anti-roll bar

Necessary preliminary work: Remove BOTH ANTI-ROLL BAR LINKS FROM ANTI-ROLL BAR. Lower REAR AXLE SUPPORT. NOTE: To simplify the graphic, anti- ...

Rear axle

...

Other materials:

BMW X3 Owners Manual > Active Blind Spot Detection: Display
Lamp in the exterior mirror housing Information stage The dimmed lamp in the exterior mirror housing indicates when there are vehicles in the blind spot or approaching from behind. Warning If the turn signal is set while a vehicle is in the critical zone, the steering wheel vibrates bri ...