Bush Mechanical tool
Replaced by: 83300492341
NOTE: (Impact bush) For radial seal on output flange - Replaced by 33 3 450. (0 492 341)
Bush AM
Replaced by: 83300493416
NOTE: (Clamping bush) Discontinuation and replaced by 33 4 400. (0 493 416)
Bush AM
NOTE: Series: E31, E46
Storage Location
C14
Bush AM
NOTE: For accommodating the trailing arm when pressing out
Storage Location
X5
Bush AM
NOTE: (Pressure bushing) For pressing the ball joint into the wishbone
Bush AM
NOTE: For accommodating the engine support arm or wheel carrier when pressing out the ball joint
Storage Location
X5
Bush AM
NOTE: (Pressure bushing) For pressing the ball joint out of the wishbone
Bush AM
NOTE: (Bush (for removal and installation)) Deletion, only available via tool set
Storage Location
C53
SI number
01 18 05 (214)
Bush AM
NOTE: For accommodating the leading link when pressing out
Storage Location
Z8
Bush Mechanical tool
NOTE: (Impact bush) For driving in the radial seal on the drive flange
Storage Location
X7
Bush AM
NOTE: For holding the wishbone when pressing out the rubber mount
Bush Mechanical tool
Replaced by: 83300492339
NOTE: (Impact bush) For fitting the radial sealing rings in the rear axle final drive on the drive flange - Replaced by 33 3 430. (0 492 339)
Bush Mechanical tool
Replaced by: 83300492340
NOTE: (Impact bush) For radial sealing ring on the drive flange without axial sealing lip (final drive type G) and for fitting the radial sealing ring of the camshaft (M40) - Replaced by 33 3 440. (0 492 340)
CASE
Case AM
NOTE: (Case) with label.
CASE
Case Minimum set: Mechanical tools AM
NOTE: (Case) Case with insert discontinued, can only be ordered using complete tool
SI number
01 22 06 (307)
CLIP
Clip Mechanical tool
NOTE: (Mounting bracket) For short neck rear axle differential - model year: from 79
Clip Mechanical tool
NOTE: (Mounting clip) For rear axle differential unit - model: 1800 - 2000CA, 2500 - 3.3L, 525, 3.0CS - 3.0CSi-L
CONNECTOR
Connector AM
NOTE: (Basic body) For transmissions S5D 260Z, S5D 310Z and S5D 320Z;Discontinued, only available via complete tool
Storage Location
Y4
Z4
BMW X3 Service & Repair Manual > Starter with mounting: Replacing solenoid switch
Turn off ignition.
Remove starter motor.
Release nut (1).
Remove cable lug (2).
CAUTION:
Do not turn cable lug (2) while tightening down - risk of short circuit to starter
motor housing.
Release screws (1).
Remove solenoid switch (1) and spring (2).
Unhook pin (3).
Install ...