IMPORTANT:
Carry out wheel alignment with DIN load only :
- If the technical prerequisites for alignment with ride height input are not fulfilled.
- If the vehicle in question is a damaged vehicle.
NOTE:
- Read and comply with GENERAL INFORMATION AND DEFINITIONS.
- Read and comply with GENERAL CHASSIS DEFINITION.
- Update KDS DATA STATES.
- Check compliance with TEST CONDITIONS, repair vehicle if necessary.
NOTE: The front and rear wheels must be positioned centrally on the rotary and sliding plates.
NOTE: Rotary plates may vary from illustration depending on the manufacturer!
NOTE: Vehicles with active steering: Start up active steering prior to wheel alignment! On vehicles with rear axle slip angle control: Service function "Moving HSR actuator to center position" is included in active steering start-up.
Attach pickup/ride height marks to vehicle (observe specifications from the various equipment manufacturers).
IMPORTANT:
Use only quick connectors with poly control pins (1).
Due to excessive measuring inaccuracy, other quick-clamping units are not permitted! Illustration of KDS II pickup
KDS DATA STATUSES
Setpoint values for wheel alignment are not published in ISTA.
The current setpoint values are made available in the workshop equipment portal.
BMW X3 Service & Repair Manual > Wheel wells: Replacing engine support/front left side frame connection (front
left wheel arch removed)
Observe procedure for REPAIR STAGE 3.
Read contents of BODY, GENERAL.
Following new body parts are required:
(1) Engine support, rear
Removing the engine support side frame connection:
Open welded connections in areas (1).
Open welded connections in areas (1).
Remove engine sup ...