BMW X3 Service & Repair Manual: Moving vehicle into design position
BMW X3 Service & Repair Manual / Suspension / Electronic chassis alignment / Moving vehicle into design position
Necessary preliminary tasks:
- Move VEHICLE INTO NORMAL POSITION.
- F01/F02/F07/F11/F15/F16: Version with air suspension system:
- Remove ignition key.
- Pull fuse for air supply unit control unit.
- Add/distribute weights in area of spring struts until the vehicle ride height is within the tolerance. Measure VEHICLE RIDE HEIGHT .
MOVING VEHICLE INTO NORMAL POSITION
Necessary preliminary tasks:
- Check compliance with TEST CONDITIONS, repair vehicle if necessary.
- F01/F02/F04/F11/F15/F16/F85/F86: Version with air suspension system: Carry out RIDE HEIGHT ADJUSTMENT .
- Check vehicle interior and luggage compartment (including spare wheel well) for load status, if applicable, unload motor vehicle.
- Introduce DIN load (refer to TECHNICAL DATA ) into vehicle.
Kds wheel alignment check with ride height measurement without vehicle load
IMPORTANT:
Do not perform wheel alignment with the vehicle unladen.
If the technical prerequisites for alignment with ride height input ...
Notes on replacement of steering gear/steering column/steering shaft
following accident damage
Steering gear facts:
In the event of accidents or driving conditions similar to accidents, shock-like loads can cause different types of
damage to s ...
Other materials:
BMW X3 Service & Repair Manual > Front side doors: Removing and installing door
IMPORTANT: Do not damage adjoining body components.
The graphics are schematic representations and are to be applied to the relevant vehicle type.
Release screw on connector frame.
NOTE: Secure door against closing.
Release screw (1) on door stop.
Open door up to limit positio ...
BMW X3 Owners Manual
BMW X3 Service & Repair Manual
© 2017-2024 Copyright www.bmwx3tech.com - 0.0181