IMPORTANT: Connecting line: In the event of moisture/corrosion inside the two plug connections, check the insulation of the connecting line. If the insulation reveals any noticeable/striking features, partial replacement will be necessary. Otherwise it will be sufficient to replace the contacts or connector housing.
NOTE: In a warranty case you must always provide a fault memory printout, even where there is no fault entry, with the defective part.
IMPORTANT: Do not turn the steering wheel once the steering shaft has been detached from the steering gear.
If the lower section of the steering shaft is separated from the steering gear, the steering column switch cluster may be damaged when the steering wheel is turned.
Necessary preliminary tasks:
NOTE: High-current-carrying wiring laid with permanent positive connection (80 A fuse).
Unlock plug connections (1) and disconnect.
Unfasten screws (2).
IMPORTANT: Risk of damage! Pay attention to connector housing on steering box while removing steering box! Press back spring strut a little.
Hold up anti-roll bar.
Carefully remove steering box towards left-hand side.
Installation note: Remount TRACK ROD END on left and right.
After installation:
BMW X3 Owners Manual > Voice activation system: Vehicle features and options
This chapter describes all standard, country-specific
and optional features offered with the
series. It also describes features that are not
necessarily available in your car, e. g., due to
the selected options or country versions. This
also applies to safety-related functions and
systems. The ...