BMW X3 Service & Repair Manual: Removing and installing/replacing airbag unit (sports steering wheel)

WARNING: Observe the following instructions to avoid any risk of injury by the airbag unit.

• Comply with safety regulations for handling components with gas generators.
• Do not exert any force on the airbag unit.
• Use only specified release tool for the airbag unit.

NOTE: Incorrect handling may result in triggering of the airbag unit and thereby cause serious injury.

IMPORTANT: Steering wheel . Follow PROCEDURE AFTER AIRBAG DEPLOYMENT.

Necessary preliminary work:

• Disconnect BATTERY EARTH LEAD .

Insert Torx screwdriver (T25) (2) at an angle into concealed opening on reverse side of steering wheel until a spring resistance is felt (approx. 1.5 cm).

Press spring leg (1) inward until airbag is unlocked.

Repeat procedure on other side.

Installation note:

Make sure electrical leads are correctly positioned.

Snap airbag unit with uniform pressing force plane-parallel in direction of steering column shaft into steering wheel.

WARNING: Danger of injury! The airbag unit may only be set down with the airbag itself facing up .

Tilt airbag unit forwards.

Disconnect plug connections and remove airbag unit.

Installation note: Connect plugs to connections of same color on airbag unit.