BMW X3 Service & Repair Manual: Renewing radial shaft seal for drive flange (atc 45l)
Special tools required:
- 23 0 490
- 27 1 430
IMPORTANT: After completion of work, CHECK TRANSMISSION OIL LEVEL and top up if necessary.
For this transfer box, use approved TRANSMISSION OIL only.
Necessary preliminary tasks:
- Remove TRANSFER BOX.
Drive a hole into radial shaft seal (1) using a center punch (2).
IMPORTANT: Do not use a drill as swarf may result in transmission failure.
Courtesy of BMW OF NORTH AMERICA, INC.
Screw special tool 23 0 490 into radial shaft seal.
Drive out radial shaft seal (1) with impact weight (2).
Installation note:
Coat sealing lips of new radial shaft seal with clean transmission oil.
Drive in radial shaft seal with special tool 27 1 430 .
Reassemble the vehicle.
Check oil level.
Check transmission for leaks.
Replacing output flange on rear transfer box (atc 45l)
IMPORTANT:
After completing work, check TRANSMISSION OIL LEVEL and top up if necessary.
Use only the approved TRANSMISSION OIL .
NOTE:
...
Other materials:
BMW X3 Service & Repair Manual > Front axle: Bush
Bush AM
NOTE:
For installing the rubber mount in the front axle support - series: E1
NOTE:
(Bush) For installing the rubber mount in the front axle support and thrust
piece, for removing and installing the rubber mount in the wishbones
Bush Mechanical tool
NOTE:
(impa ...
BMW X3 Owners Manual
BMW X3 Service & Repair Manual
