Position of switch: , ,
If the driver door is opened with the ignition switched off, the exterior lighting is automatically switched off at these switch settings.
Parking lights
Position of switch : the vehicle's lights light up on all sides, e.g., for parking.
Do not use the parking lights for extended periods; otherwise, they might drain the battery and it would then be impossible to start the engine.
When parking, it is preferable to switch on the one-sided roadside parking lights.
Low beams
Position of switch with the ignition switched on: the low beams light up.
Welcome lights
When the vehicle is parked, leave the switch in position or : parking and interior lights come on briefly when the vehicle is unlocked depending on the ambient brightness.
Activating/deactivating
1. "Settings"
2. "Lighting"
3. "Welcome lights"
Settings are stored for the profile currently in use.
Headlight courtesy delay feature
The low beams stay lit for a short while after the radio-ready state is switched off if the lights are turned off and the headlight flasher is switched on.
Setting the duration
1. "Settings"
2. "Lighting"
3. "Pathway lighting:"
4. Set length of time.
Settings are stored for the profile currently in use.
BMW X3 Owners Manual > Active Cruise Control with
Stop & Go function, ACC: Radar sensor
For US owners only
The transmitter and receiver units comply with
part 15 of the FCC/Federal Communication
Commission regulations. Operation is governed
by the following:
FCC ID:
OAYARS3-A
Compliance statement:
This device complies with part 15 of the FCC
Rules. Operation is subject to ...