BMW X3 Owners Manual: Condition Based Service CBS

BMW X3 Owners Manual / Mobility / Maintenance / Condition Based Service CBS

Sensors and special algorithms take into account the driving conditions of your vehicle.

Based on this, Condition Based Service recognizes the maintenance requirements.

The system makes it possible to adapt the amount of maintenance corresponding to your user profile.

Detailed information on service requirements, can be displayed on the Control Display.

Service data in the remote control

Information on the required maintenance is continuously stored in the remote control.

Your service center will read out this data and suggest the right array of service procedures for your vehicle.

Therefore, hand your service specialist the remote control with which the vehicle was driven most recently.

Storage periods

Storage periods during which the vehicle battery was disconnected are not taken into account.

If this occurs, have a service center update the time-dependent maintenance procedures, such as checking brake fluid and, if needed, changing the engine oil and the microfilter/ activated-charcoal filter.

Service and Warranty Information Booklet for US models and Warranty and Service Guide Booklet for Canadian models

Please consult your Service and Warranty Information Booklet for US models and Warranty and Service Guide Booklet for Canadian models for additional information on service requirements.

Maintenance and repair should be performed by your service center. Make sure to have regular maintenance procedures recorded in the vehicle's Service and Warranty Information Booklet for US models, and in the Warranty and Service Guide Booklet for Canadian models.

These entries are proof of regular maintenance.

    Vehicle features and options
    This chapter describes all standard, country-specific and optional features offered with the series. It also describes features that are not necess ...

    Socket for OBD Onboard Diagnosis
    Note Socket for Onboard Diagnosis The socket for onboard diagnostics may only be used by the service center or a workshop that operates in accorda ...

    Other materials:

    BMW X3 Service & Repair Manual > Electronic switching or control units: Replacing suction pressure sensor on intake plenum (N20, N26)
    Necessary preliminary tasks: Read out the fault memory of the DME control unit. Switch off ignition. Partially undo the acoustic cover. Unlock connector (1) and remove. Unfasten screws (2). Pull out the vacuum pressure sensor (3) from the intake plenum. Installation note: Check ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2024 Copyright www.bmwx3tech.com - 0.0301