BMW X3 Service & Repair Manual: Straightening steel components in the structure

BMW X3 Service & Repair Manual / Body and Frame / Body repair instructions / Straightening steel components in the structure

  • High-strength and super-high-strength steel plates as a rule cannot be reshaped. Reshaping only serves as a preparatory measure to replacing the component in order to achieve optimal joining of the connection points.
  • Bearing body components such as e.g. engine supports, door pillars, side members etc. with deformations which can no longer be returned to their original shape by "cold straightening" must be replaced.
    Heating bearing body components for better reshaping is not permitted! Failure to comply with this requirement would result in a loss of original strength of up to 40 %.
  • The body must be anchored as follows for reshaping:
    If using vehicle-specific/universal straightening attachment sets (Carbench/Celette/Car-O-Liner), it is necessary to secure the body additionally with 4 retaining clips to the spot flange of the entrance or to the 4 jacking points. The spot flange (if available) is to be preferred.

    If using universal electronic or mechanical straightening systems (Car-O-liner/Celette), it is necessary to secure the body with 4 retaining clips to the spot flange of the entrance or to the 4 jacking points. The spot flange (if available) is to be preferred. In addition anchor at least 2 points with the securing set.

    Failure to comply with these instructions will result in damage to the body during reshaping in non- damaged areas. Vehicle-specific straightening attachments and universal mounts may be damaged.

  • Repairs affecting the mounting points of assemblies and chassis/suspension components must be carried out on the straightening bench with the matching straightening attachment set or specification sheet for the vehicle.

    Straightening attachments and specification sheets are also available for the top section, e.g.: door pillars, convertible top mounts, cowl, rear lid hinges, etc.

  • Check windshield and rear window apertures for curvature by inserting the original glass.
  • Take the gap dimensions for doors, engine hood and rear lid from the vehicle-specific gap dimension diagram.
    Straightening aluminum components in structure
    Reshaping or heating extruded profiles and cast parts is not permitted! Failure to comply with this requirement would have the following resul ...

    Straightening steel components on the outer skin
    1.0 Recommended tools. Only use those tools designed for steel repairs. 2.0 Straightening outer skin. "Cold" straightening: Press dents out from ...

    Other materials:

    BMW X3 Service & Repair Manual > Zf transmissions: GA6HP19Z
    E60/61 525i, 530i from 8/03 production to present The transmission fluid has a Condition Based Service interval of approximately 100, 000 miles; refer to S.I. B00 07 02 for further information. Never mix any other oil with this transmission fluid when doing repairs or topping up. Shell M ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2024 Copyright www.bmwx3tech.com - 0.0084