BMW X3 Service & Repair Manual: Working with 2-component PU cavity foam

BMW X3 Service & Repair Manual / Body and Frame / Body repair instructions / Working with 2-component PU cavity foam

Properties of cavity foam:

  • 2-component PU foam, solvent-free.
  • Excellent flow capacity, enabling complete sealing of cavities.
  • Good strength, preventing slipping in cavities.
  • Low water absorption, preventing corrosion.
  • Ideal for use as insulating and sealing compound

Information on dangers/hazards:

  • Avoid eye and skin contact.

    Wear protective goggles, solvent-resistant protective gloves and protective clothing.

  • Do not inhale.

    Apply in well ventilated rooms only.

WARNING: Application time after mixing: within 8 minutes!

  • Completely empty open can after use.
  • Remaining amounts which are not used can cause the can to explode on account of a chemical reaction (buildup of heat)!
    Alternatively, cool the can containing the non-removed remaining amount for several hours in cold water.
  • Do not eat, drink or smoke during this operation.
  • Keep heat and ignition sources well away.
  • Read the manufacturer's information on hazards/dangers (printed on the can) prior to application.

Application instructions:

  • Use by date on can.

    Do not use the spray can after the Use by date on the can has expired. After the Use by date the properties of the cavity foam will no longer meet the requirements of the BMW Group.

  • Cavity sealing of repair area possible after an air drying time of 1 hour.
  • Backing surface must be clean and free from dust, grease, oil and stripping agent.
  • Application temperature at least 15 ºC. Optimally 20 ºC.
  • Remove fresh, non-hardened PU foam with adhesive cleaner 208.

    Sourcing reference: BMW Parts Service.

    Hardened PU foam can only be removed by mechanical means (machine).

  • Excess, hardened PU foam can be disposed of as residual waste.

    Cans which are not entirely empty and unused whose Use by date has expired are classed as hazardous waste.

    Observe country-specific waste-disposal regulations.

  • Observe the manufacturer's application instructions (printed on the can).

IMPORTANT: Foam expands many times over as it sets (change in volume).

  • Setting takes approx. 30 minutes. Mechanical processing (e.g. drilling, cutting, etc.) is then possible.
    Welding steel components
    IMPORTANT: Comply with the following topics from "Body, General": Safety regulations . Handling electrical system, electronics, airbags and ...

    Workshop equipment (BMW and mini vehicles)
    Minimum workshop equipment requirements in order to ensure the correct and expert performance of body repairs: The tools listed below must be used ...

    Other materials:

    BMW X3 Service & Repair Manual > Transfer box special tools: Puller
    Puller Mechanical tool NOTE: For withdrawing the radial shaft seals in the transfer box on the output shaft at the front Puller AM NOTE: For pulling out the transfer box rubber mount Consisting of: 1. Bush NOTE: (Pull-out bush) 2. Spindle 3. Nut NOTE: (Thrust nut with bearing) ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2024 Copyright www.bmwx3tech.com - 0.011