Read contents of BODY, GENERAL.
STRIP DOWN VEHICLE
Observe procedure for (REPAIR STAGE 2)!
Following new body parts are required:
Following CONSUMABLES are required:
Removal of luggage compartment floor
Open welded connections in area (1).
Remove the luggage compartment floor.
New part preparation
Adjust new part in conjunction with tail panel and secure.
In areas (1) and (2) set 4.2 mm dia. holes for blind rivets.
Remove new parts and deburr bore holes.
IMPORTANT: Do not grind new part and body in area of bonding surfaces.
Installation of luggage compartment floor:
Clean all bonding surfaces with cleaning agent R1.
Apply adhesive to bonding surfaces.
Install new part and rivet with blind rivets.
After hardening of the adhesive install 6 EMC SCREWS in the areas shown (1).
BMW X3 Service & Repair Manual > Electronic switching or control units: Replacing suction pressure sensor on intake plenum (N20, N26)
Necessary preliminary tasks:
Read out the fault memory of the DME control unit.
Switch off ignition.
Partially undo the acoustic cover.
Unlock connector (1) and remove.
Unfasten screws (2).
Pull out the vacuum pressure sensor (3) from the intake plenum.
Installation note:
Check ...