Procedure OBSERVE repair stage 3!
Read contents of BODY, GENERAL.
Use only an approved SPOT-WELDING APPARATUS for repairs! Following new body parts are required (see OVERVIEW OF CONSUMABLES):
Removal:
Mark severance cuts in accordance with specified dimensions and cut.
IMPORTANT: Cut outer panel only for following severance cuts.
Dimension a = approx. 180 mm after center point of Ø 8 mm hole.
Dimension b = approx. 175 mm from edge of roof frame.
Dimension c = approx. 180 mm from center point of Ø 20 mm hole.
Open welded connections in areas (1).
Release A-pillar from cavity sealing (2) and remove.
Preparation of new part: Mark severance cuts on new parts in accordance with severance cuts on vehicle and cut.
Prepare REINFORCEMENT PLATES at severance cuts.
Installation:
Apply sealant to cavity sealing .
Install new parts and reinforcement plates and weld to designated area (2).
BMW X3 Service & Repair Manual > Torque converter: Removing and installing/replacing torque converter (GA8HP45Z)
(N52)
Special tools required:
00 2 550
24 4 000
IMPORTANT:
Do not let skin come in contact with transmission oil and do not inhale transmission oil
vapors.
Wear protective gloves.
Ensure adequate ventilation
IMPORTANT:
After completion of repair work, check TRANSMISSI ...