BMW X3 Service & Repair Manual: Replace roof outer skin with slide/tilt sunroof

Read contents of BODY, GENERAL.

STRIP DOWN VEHICLE

NOTE: Observe (REPAIR STAGE 2) procedure!

Following new body parts are required:

• (1) Roof outer skin panel, panorama glass sunroof

Following CONSUMABLES are required:

Removing roof outer skin: Open welded connections in area (1).

Open brazed connections in areas (1) by grinding.

Open welded connections in areas (2).

Release screws (1).

OPEN bonded connections in areas (1).

Take off roof outer skin.

Preparation of new part: Adjust roof outer skin to fit and secure.

In area (1) drill 1 Ø 4.2 mm hole for blind rivet.

Shown on left side, right side identical.

Remove new part again and deburr bore holes.

IMPORTANT: Do not grind/sand new part in area of bonding surfaces.

Installing roof outer skin: Clean all bonding surfaces on vehicle and on new part with cleaning agent R1.

In areas (1), apply sealant D1 in the same way as in series standard.

Apply adhesive in area (2).

Apply a little more adhesive to node of A-pillar.

NOTE: Excess material at the nodes is later used for spreading to side frame.

Place roof outer skin with helpers evenly and centrally on vehicle, adjust to fit and secure.

Rivet roof outer skin with blind rivets.

Insert screws (1) and tighten down.

Secure roof outer skin with screws and nuts M6 at mounting holes (1) of roof rails.

In area (1) rivet roof outer skin with 9 N4 punch rivets.

Use N4 punch rivets in areas (1) to (3).

A-pillar nodes: Adapt step (1) between roof outer skin (2) and A-pillar with emerging adhesive. Remove excess adhesive.

IMPORTANT: Do not use any cleaning agents containing solvents.

Do not leave any traces of sharp edges as this could compromise the tightness of the subsequent bond.

Install hinges for tailgate until the adhesive has hardened.

Avoid contact between emerging adhesive and hinges! Remove excess adhesive.

IMPORTANT: Do not use any cleaning agents containing solvents.

Seal adhesive areas and blind rivets with sealant D1.

IMPORTANT: Spread excess adhesive in roof trim strip channel. Mounting surfaces of clips for roof trim strips must not be moistened with adhesive.

Operation is described on the left side. Right side identical.

Graphic similar.

Fit an EMC SCREW after adhesive has hardened in area (1).

In so doing, bear in mind subsequent fitting of roof trim strip/roof rail!