BMW X3 Service & Repair Manual: Dash cowl

BMW X3 Service & Repair Manual / Body and Frame / Dash cowl

REPLACE THE A-PILLAR ON THE OUTSIDE LEFT IN THE AREA OF THE WINDSCREEN

Read contents of BODY, GENERAL.

Remove or cover those vehicle components in the repair area which are susceptible to heat or dust.

Use only approved SPOT-WELDING APPARATUS for repairs.

IMPORTANT: Operations on pyrotechnical devices may only be carried out by authorized experts.

Improper, unauthorized operations may result in serious dangers.

Unauthorized persons are strictly prohibited from performing any operations on this system.

WARNING: Read and comply with SAFETY INSTRUCTIONS for handling airbag modules and pyrotechnical belt tensioners.

Incorrect handling can activate airbag and cause injury.

A damaged head airbag must be replaced.

A damaged head airbag exhibits an impaired protective function and in extreme cases loses its protective function altogether.

Necessary preliminary tasks:

Disconnect BATTERY EARTH LEAD
Remove PANEL FOR ROOF PILLAR

Following new body parts are required :

(1) A-pillar with entrance

Body+and+Frame

Removing the A-pillar in the area of the windscreen

Unclip wiring harness in these areas (1).

Undo airbag at the attachment points (2).

IMPORTANT: For the exact procedure, see repair instructions for REMOVING AND INSTALLING HEAD AIRBAG !

IMPORTANT: Risk of damage! Airbag must not be kinked or bent!

Body+and+Frame

NOTE: Use protective sleeve (1) to protect the airbag.

Check protective sleeve for damage prior to use.

A damaged protective sleeve must not be used!

(2) Velcro fastener
(3) Loop

Body+and+Frame

Push the protective sleeve (1) onto the airbag up to just below the roofliner so that the airbag is completely covered.

Fasten protective sleeve with Velcro fastener (2).

Secure protective sleeve with airbag against kinking.

Body+and+Frame

Mark severance cuts in accordance with specified dimensions and cut.

IMPORTANT: Cut outer panel only for following severance cuts.

Dimensions a = approx. 150 mm from roof edge.
Dimension b = approx. 340 mm below severance cut a.

Open welded connections in areas (1).

New part preparation

Mark severance cuts on new parts in accordance with vehicle and cut.

Prepare REINFORCEMENT PLATES at severance cuts.

Installing the A-pillar in the area of the windscreen

Install and weld new parts and reinforcement plates.

After completing welding work: Check airbag in area of protective sleeve for damage, REPLACE if necessary.

REPLACING OUTER RIGHT A-PILLAR IN AREA OF WINDSCREEN

Operation is identical to replacing "OUTER LEFT A-PILLAR IN AREA OF WINDSCREEN".

Stripping operations - replacing roof outer skin (version with panorama glass roof)

NOTE: Owing to the different engine variants and equipment specifications, not all the components are taken into consideration. The follow ...

Front trim panel

NOTES ON THE REPAIR TECHNIQUE USED IN THE MAIN GROUP 41 Two different repair techniques are used in body repair. These are welding and bonding/riv ...

Other materials:

BMW X3 Owners Manual > Without remote control: From the outside
Locking from the outside Do not lock the vehicle from the outside with people inside the car, as the vehicle cannot be unlocked from inside without special knowledge. Remove the key before pulling the door handle Before pulling the outside door handle, remove the key to avoid damaging the pa ...