BMW X3 Service & Repair Manual: Removing and installing front panel
Necessary preliminary tasks:
- Remove FRONT BUMPER TRIM .
Unlock plug-in connector (1) for horn and disconnect.
Shown on left side, right side identical.
Open clutch (1) and detach Bowden cable for hood/bonnet release.
Release screw (2).
Unlock plug connection (3) for headlight and disconnect.
Unlock plug connection for wiring harness (4) and disconnect.
Release screws (5).
Release screw (1).
Unlock plug connection (2) for headlight and disconnect.
Release screws (3).
Pull out retainer (2) upwards.
Press the 5 latch mechanisms inward and remove bearing pin (2) upward.
Shown on left side, right side identical.
In case of damage during disassembly, replace bearing pin (plug).
Release screws (1) on engine support on both sides and remove front panel.
Installation note: When mounting the front panel, ensure that the intake air channel (1) is correctly positioned.
Installation note: In area (1), ensure that the side wall and headlight are correctly positioned.
Front trim panel
NOTES ON THE REPAIR TECHNIQUE USED IN THE MAIN GROUP 41
Two different repair techniques are used in body repair.
These are welding and bonding/riv ...
Replacing front left or right side wall holder
NOTE: Read contents of BODY, GENERAL.
Side wall removed.
Transfer the systematic diagram onto the respective holder version.
General inf ...
Other materials:
BMW X3 Service & Repair Manual > Spring strut: Replacing front left or right spring strut shock absorber
Special tools required:
31 3 340
31 3 341
31 3 355
33 0 040
31 0 040
WARNING:
Prior to each use of special tool 31 3 340, it is essential to read the associated
Owner's Handbook fully!
All the safety precautions and instructions contained in the Owner's Handbook
must be st ...
BMW X3 Owners Manual
BMW X3 Service & Repair Manual
