BMW X3 Service & Repair Manual: Brakes
BMW X3 Service & Repair Manual / Brakes
- General information
- Handling brake fluids
- Brake testing and bleeding
- Bleeding brake system with dsc
- Checking brakes on test stand
- Checking thickness of brake pad
- General notes
- Guideline for applying brake pad paste on brake pads and brake anchor plate
- Minimum brake disc thickness
- Parking brake (emf) - additional brake bleeding procedure
- Parking brake function check
- Removing and installing/replacing vent valve for brake caliper
- Replacing fluid in brake system
- Safety information for working on vehicles with automatic engine start-stop function (msa)
- Front brakes
- Precision-turning both front brake discs on both sides
- Removing and installing/renewing brake pads on both front disc brakes
- Removing and installing/replacing both front brake discs
- Removing and installing/replacing left or right front brake caliper
- Removing and installing/replacing vent valve for brake caliper
- Replacing front left or right brake anchor plate/guard plate
- Rear brakes
- Guideline for applying brake pad paste on brake pads and brake anchor plate
- Precision-turning both rear brake discs on both sides
- Removing and installing or replacing both rear brake discs
- Removing and installing or replacing brake pads on both rear disc brakes (trw floating caliper)
- Removing and installing or replacing rear left or right brake caliper (trw)
- Removing and installing/renewing a brake anchor plate/brake guard plate at rear
- Removing and installing/replacing vent valve for brake caliper
- Replacing rear left or right dust boot on brake caliper
- Master brake cylinder
- Removing and installing/replacing expansion tank for hydraulic brake control
- Removing and installing/replacing tandem brake master cylinder for dsc
- Brake lines
- Brake booster
- Removing and installing brake booster vacuum pressure sensor
- Removing and installing or replacing brake booster
- Replacing vacuum hose for brake booster (N63)
- Replacing vacuum hose for brake booster (diesel fuel)
- Replacing vacuum hose for brake booster (petrol)
- Electrical components/wear indicator
- Parking brake
- Electromechanical parking brake - emergency release
- Removing and installing control unit for parking brake
- Removing and installing/replacing emf actuator
- Mechanical/hydraulic components
- Removing and installing brake booster vacuum pressure sensor
- Removing and installing/replacing dsc hydraulic unit
- Electronic components
- Removing and installing/renewing icm control unit
- Removing and installing/replacing dsc control unit
- Removing and installing/replacing emf actuator
- Replacing a brake pad sensor (front)
- Replacing a brake pad sensor (rear)
- Replacing a rear pulse generator
- Replacing one front pulse generator
- Brakes
- Adapter
- Adapter cable
- Device
- Gauge
- Holding sleeve
- Pin wrench
- Reset
- Ring spanner
- Shaped part
- Spindle
- Tool
- Wrench
- Front brake
- Pedal mounting block
- Brake pedal with linkage
- Clutch pedal with linkage
- Removing and installing or replacing clutch pedal
- Removing and installing/replacing over-center helper spring
- Accelerator pedal actuation
- Pedals
Tool set
Tool set Mechanical tool
NOTE: Tool set for M5 threaded insert
SI number
01 02 14 (069)
Tool set Mechanical tool
SI number
01 02 14 (069) ...
General information
Brake fluid, (glycol-based) as used in BMW brake systems, must conform with the following requirements:
High boiling point
Good low temperature ...
Other materials:
BMW X3 Service & Repair Manual > Compressor: Replacing air conditioning system compressor (N55) (version 2)
Special tools required:
00 9 030
32 1 270
WARNING: Danger of injury!
Refrigerant circuit is under high pressure!
Avoid contact with refrigerant and refrigerant fluid.
Read and comply with safety instructions:
Handling R 134a refrigerant .
HANDLING REFRIGERANT FLUID
IMPORTA ...
BMW X3 Owners Manual
BMW X3 Service & Repair Manual
© 2017-2024 Copyright www.bmwx3tech.com - 0.0378