Necessary preliminary tasks:
IMPORTANT: Switch off ignition at least 30 s before disconnecting the plug connection!
After installation, observe the following: switch on ignition and, using parking brake operating element, open parking brake once, close once and open again.
Disconnect plug connection (1).
Disengage cable from cable clip.
Release screws (1).
Installation note: Replace screws
Take off holder (2).
Detach actuator drive (3) from brake caliper.
Installation note: Check sealing ring (1), replace if necessary.
Apply a light coating of brake fluid to sealing ring (1) before fitting.
Installation note: Carefully fit actuator drive until teeth engage and actuator drive rests flush on brake caliper.
If necessary, turn actuator drive slightly until bore hole and thread are flush.
BMW X3 Service & Repair Manual > Electronic chassis alignment: Additional work for camber correction
IMPORTANT:
Changes in axle geometry caused by accidents must under no circumstances be rectified by
camber adjustment!
NOTE:
The swivel bearing may only be replaced if the camber is outside the specified
tolerance after toe adjustment.
Necessary preliminary tasks:
Adjust TOE-IN.
Ch ...