IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD protection).
Necessary preliminary work:
Unclip line from holder (1).
Open housing cover.
Disconnect plug connection (2).
Installation note: Make sure the plug connections snaps in correctly and the line is fitted correctly in the holders.
Unclip line from holders (1).
Installation note: Ensure proper locking of the holders and proper seating of the line in the holders.
Release screw (1) and withdraw pulse generator (2) from bore.
Unclip line from holder (3).
Clean bore for pulse generator and lubricate with Staburags NBU 12/K lubricating grease.
IMPORTANT: Prior to installation, check sensor head for damage and replace if necessary.
START-UP OF ICM CONTROL UNIT
NOTE: Start-up of ICM control unit must be carried out:
- After replacement or removal and installation of ICM control unit
Connect vehicle to BMW diagnosis system.
Select and carry out start-up of ICM control unit under Service functions.
BMW X3 Service & Repair Manual > Engine wiring loom: Removing and installing/replacing engine sensor system wiring harness module 1 (N20, N26)
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC
DISCHARGE (ESD PROTECTION) .
Necessary preliminary tasks:
Read out the fault memory of the DME control unit.
Switch off ignition.
Remove INTAKE PLENUM .
Overview, engine sensor system wiring harness modu ...