Shaped part AM
NOTE: (Shaped parts)
SHELL
Shell Mechanical tool
NOTE: (bearing shells) 2 pieces For the pressure accumulator of the H31brake system
Storage Location
Y2
SI number
01 04 88 (906)
SOCKET
Socket Mechanical tool
NOTE: For installing the DSC 3 pressure sensor - from 9/98
Storage Location
A11
SI number
01 14 98 (343)
SOCKET WRENCH INSERT
Socket wrench insert Mechanical tool
NOTE: (Screwdriver insert) For front brake calipers - Deletion since June 85
NOTE: Hexagon socket WAF 7, connection 1/2" for replacing the brake pads
Storage Location
X3
NOTE: (Screwdriver insert) For releasing and tightening the spline socket screws on the fixed brake yoke at the front and rear
Storage Location
C7
BMW X3 Service & Repair Manual > Output shafts: Removing and installing/replacing both output shafts
IMPORTANT:
The RADIAL SHAFT SEAL FOR THE OUTPUT SHAFT should be renewed every
time the output shaft is removed and installed.
The circlip of the output shaft must be replaced after re-installation.
NOTE: The procedure is described in PRESSING OUTPUT SHAFT OUT OF DRIVE
FLANGE AN ...