REMOVING AND INSTALLING (REPLACING) COMPLETE BEARING SUPPORT FOR FOOT PEDAL
IMPORTANT: When the repair work is complete, please pay attention to the following:
- Bleed clutch hydraulic system.
- Carry out functional check.
Necessary preliminary work:
Remove sensor opening (1).
Lower the level in the expansion tank below the output to the clutch master cylinder.
Detach hose (1) from expansion tank in direction of arrow.
Press out plastic pin (1).
Press plastic pin (2) together and press out.
Installation note: Replace plastic pins (1 and 2).
Remove clutch master cylinder from the bearing support. Feed hose through the bearing support out of the expansion tank.
IMPORTANT: Note draining brake fluid and catch in a suitable collecting vessel, if applicable.
Remove retaining clip (1) and press out pin.
Unscrew nuts (2).
Installation note:
Make sure the retaining clip is fitted correctly in the groove! Check retaining clip and replace if necessary.
Replace self-locking nut.
Disconnect plug connection (1).
Remove line clip (2).
Undo nut (3) and remove bearing support.
Installation note: Replace self-locking nut.
Replacement:
BMW X3 Service & Repair Manual > Pedals: Gauge
Gauge Minimum set: Mechanical tools AM
Replaced by: 83300493311
NOTE: (Adjusting gauge) For adjusting the full load stop (kickdown switch) on the
accelerator. Replaced by 35 0 012. (0 493 311)
Storage Location
C32
SI number
01 11 94 (858)
Consisting of:
4 = Gauge
NOTE: (Adjusting ...