Necessary preliminary work:
Press end of pin (1) together with offset pliers and press out pin.
Push in pin (1) fully in direction of arrow.
Detach retainers (1).
Installation note: Check retainers, replace if necessary.
Retainers must lie with both legs in the groove and snap audibly into place.
Slide out pin (2).
Installation note: Lightly grease pin.
Remove over-centre helper spring (3).
There are two versions:
Assembly of over-centre helper spring:
Lightly grease holder and spring contact surfaces.
Installation note: Secure over-centre helper spring first with black holder to clutch pedal.
Gently press over-centre helper spring together and secure with grey holder to bearing block.
Connect clutch pedal to clutch master cylinder.
When replacing reinforced over-centre helper spring: Remove locking clamp (1).
REPLACING BEARING BUSHES FOR CLUTCH PEDAL
Operation is described in: REMOVING AND INSTALLING CLUTCH PEDAL.
BMW X3 Service & Repair Manual > Engine electrical system: Tool
Tool Mechanical tool
NOTE: (Tool) for ignition timing adjustment (CIFI)
Tool AM
NOTE: (Tool set) to open and close the electronics box
Storage Location
J 106
Consisting of:
1 = Pliers
NOTE: For bending the sheet metal tabs open
2 = Lever
NOTE: For bending the sheet metal tabs
3 = ...