Special tools required:
Necessary preliminary tasks:
Completely fill centring bore hole (1) with viscous grease.
Drive special tool 11 1 310 with a plastic hammer into centring bore hole.
The centring bearing (1) is forced out of the propeller shaft by the pressure on the grease filling.
If necessary, top up grease repeatedly.
NOTE: To drive out the bearing, you can also fill the centring bore hole with water instead of grease.
Installation note: Remove grease or water from mount bore.
Drive in centring mount (1) with special tools 11 2 030 and 00 5 500 into propeller shaft (observe protrusion).
Grease centring mount.
Installation note: Observe protrusion A = 4+2 mm of centring (1).
BMW X3 Service & Repair Manual > Engine wiring loom: Replacing the wiring harness section for the engine transmission module (N20)
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC
DISCHARGE (ESD PROTECTION) .
Necessary preliminary tasks:
Read out the fault memory of the DME control unit.
Switch off ignition.
Remove intake PLENUM .
Remove rear UNDERBODY PROTECTION .
Remove cross mem ...