Necessary preliminary tasks:
NOTE: The propeller shaft is balanced.
The front and rear propeller shafts must be reassembled in the same position.
Detach gaiter (1) from groove (2).
Mark front propeller shaft (3) and rear propeller shaft (4) in one plane.
Pull apart propeller shaft.
Installation note: If necessary, insert new clamping ring (1) into front propeller shaft (2).
Release gaiter (1) with screwdriver from groove (2) and pull off over longitudinal splines.
Installation note: Apply an even coating of grease to longitudinal splines on shaft.
Observe markings and force front propeller shaft onto longitudinal splines (markings must be flush).
Push gaiter (1) during installation into groove (2) and make sure it is firmly fitted.
BMW X3 Owners Manual > Without remote control: From the outside
Locking from the outside
Do not lock the vehicle from the outside
with people inside the car, as the vehicle cannot
be unlocked from inside without special
knowledge.
Remove the key before pulling the door
handle
Before pulling the outside door handle, remove
the key to avoid damaging the pa ...