BMW X3 Service & Repair Manual: Removing and installing/replacing guide joint in swivel bearing

BMW X3 Service & Repair Manual / Driveline+Axles / Struts with rubber mounts / Removing and installing/replacing guide joint in swivel bearing

Necessary preliminary work:

  • Remove TENSION STRUT FROM GUIDE JOINT.

IMPORTANT: Check the rubber gaiter and circlip for damage! When removing and installing the trailing link, check the seat of the circlip seal between the trailing link and the wheel control joint and replace the wheel control joint if needed!

Release screw (1).

Remove guide joint from swivel bearing.

Installation note: Rework thread in swivel bearing.

Keep guide joint and bore hole in swivel bearing clean and free from oil and grease.

Replace microencapsulated screw.

Driveline+Axles

    Removing and installing left or right wishbone
    Special tools required: 31 2 242 31 2 246 31 2 240 NOTE: If the wishbone is detached from the front axle support, it will be necessar ...

    Removing and installing/replacing left or right trailing link
    Special tools required: 31 2 242 31 2 246 31 2 240 Necessary preliminary tasks: Remove FRONT WHEEL . Remove UNDERBODY PROTECTION. P ...

    Other materials:

    BMW X3 Owners Manual > Comfort Access: Opening and closing the tailgate with no-touch activation
    The tailgate can be opened with no-touch activation using the remote control you are carrying. With automatic tailgate operation, it can also be closed with no-touch activation. Two sensors detect a forward-directed foot motion in the center of the area at the rear of the car and the trunk l ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2024 Copyright www.bmwx3tech.com - 0.0109