Laser Minimum set: Mechanical tools AM
LEVER
Lever AM
NOTE: Lever in connection with hydraulic cylinder (hydraulic actuator), (81 64 2 156 246), for removal and installation of wheel bearings, propeller shafts and drive flanges.
SI number
08 06 09 (544)
LOCATING FIXTURE
Locating fixture Minimum set: Mechanical tools AM
NOTE: For attaching and aligning the laser on the spring strut.
BMW X3 Service & Repair Manual > Control arms and struts: Removing and installing/replacing left or right camber arm
IMPORTANT:
If the camber arm is bent, the control arm/wheel carrier screw connection must be
renewed.
NOTE: If the camber arm is renewed, the wheel alignment .
Necessary preliminary work:
Remove REAR WHEEL .
Support wheel carrier with workshop jack!
Mark position of eccentric adj ...