IMPORTANT:
- The RADIAL SHAFT SEAL FOR THE OUTPUT SHAFT should be renewed every time the output shaft is removed and installed.
- The circlip of the output shaft must be replaced after re-installation.
NOTE: The procedure is described in PRESSING OUTPUT SHAFT OUT OF DRIVE FLANGE AND DRAWING IN.
After installation:
REMOVING AND INSTALLING/REPLACING LEFT OR RIGHT OUTPUT SHAFT
IMPORTANT: The RADIAL SHAFT SEAL FOR THE OUTPUT SHAFT should be renewed every time the output shaft is removed and installed.
The circlip of the output shaft must be replaced after re-installation.
NOTE: The procedure is described in REMOVING AND INSTALLING STEERING STUB/WHEEL CARRIER.
After installation:
BMW X3 Service & Repair Manual > Front axle: Fork
Fork Mechanical tool
NOTE: (Press-off fork) For pressing the output shaft off of the front axle differential
(all-wheel drive vehicles)
SI number
01 17 05 (212)
Fork AM
NOTE: (Separating fork)
Fork AM
NOTE:
(Separating fork) for separating the conical seat at the wheel guide joint from ...