IMPORTANT: If the camber arm is bent, the control arm/wheel carrier screw connection must be renewed.
NOTE: If the camber arm is renewed, the wheel alignment .
Necessary preliminary work:
Support wheel carrier with workshop jack! Mark position of eccentric adjustment washer to rear axle support to simplify subsequent adjustment of rear axle.
Release nut (1) and remove eccentric bolt.
Installation note: Note insertion direction of eccentric screw.
Renew nut, eccentric bolt.
Tighten down screw connection in NORMAL POSITION .
Release nut (2) and remove screw.
Installation note: Note direction of insertion of screw.
Replace screw and nut.
Release nut (3) and remove screw.
Installation note: Note direction of insertion of bolts.
Replace screw and nut.
After installation:
BMW X3 Service & Repair Manual > Engine and gearbox suspension: Device
Device AM
In conjunction with: 33 4 465/466, 22 1 102, 22 1 046 = 0496792
NOTE: For removing and installing the rubber mount.
Storage Location
C28
SI number
01 03 10 (619)
Consisting of:
1. Bridge
NOTE: For removing rubber mount.
2. Washer
NOTE: For removing rubber mount
3. Wa ...