Release screw.
Installation note:
Replace screw.
Tighten down screw connection in NORMAL POSITION .
IMPORTANT: When installing, ensure that the tapered side of the bearing bush is connected first toward the wheel carrier.
Slacken nut (1).
Unscrew bolt towards rear and remove control arm (2).
Installation note:
Bolt head must point to rear.
Replace screw and nut.
Tighten down screw connection in NORMAL POSITION .
BMW X3 Service & Repair Manual > Rear axle repair instructions: Information on replacing shock absorbers
Situation:
When a shock absorber is faulty on one side (leaking, noises, limit values exceeded on the shock tester), often
both shock absorbers on the axle in question are replaced.
Effect:
This is not necessary for technical reasons and causes the manufacturer not to recognize the unneces ...