IMPORTANT:
- The wishbone must be installed with the opening (U-section) facing downward!
- If the wishbone is bent, the screw connection between the control arm and wheel carrier must be replaced.
Necessary preliminary work:
Release left and right screws (1). Slide anti-roll bar (2) forward.
Installation note:
Replace screws.
Release nut (1) and remove screw towards front.
Installation note: Tighten down screw connection in NORMAL POSITION .
Replace screw and nut.
Release nut (1) and remove screw towards front.
Remove wishbone (2).
Installation note: The wishbone must be installed with the opening (U-section) facing downward! Raise wheel carrier using workshop jack.
Bolt heads face in forward direction.
Replace screw and nut.
After installation:
BMW X3 Service & Repair Manual > Brakes: Ring spanner
Ring spanner AM
NOTE: (Ring spanner 19 mm)
NOTE:
(Open ring spanner) Open ring spanner set, for unfastening and tightening the
pressure lines on the pressure regulator and brake servo, H31-brake system
Storage Location
A12
Consisting of:
1. Ring spanner
NOTE: (Ring ...