NOTE: To simplify the graphic, anti-roll bar removal is shown on the removed rear axle.
Release screws (1).
Remove both RUBBER MOUNTS FROM ANTI-ROLL BAR.
Turn anti-roll bar (2) and remove from the side.
Installation note:
Check both rubber mounts for damage and replace if necessary.
Keep retaining bracket, rubber mount and stabilizer clean and free from oil and grease.
BMW X3 Service & Repair Manual > Transfer box: Replacing output flange for front axle output (atc 450)
IMPORTANT:
Do not move vehicle with drive power once propeller shaft has been removed.
Replace output flange only together with a new radial shaft seal.
After completion of work, check gearbox oil level.
Use only the approved TRANSMISSION OIL .
Failure to comply with this requir ...