Extractor AM
NOTE: (Rillex extractor) For bevel pinion and differential case (rear diff)/for installation of camshaft sprocket on crankshaft (M70)/for removing bearing inner race from drive flange (E36, E46)
Storage Location
Y4
Z4
Consisting of:
1 = Connector
NOTE: (Basic body) For transmissions S5D 260Z, S5D 310Z and S5D 320Z;Discontinued, only available via complete tool
2 = Washer
NOTE: (Disc) Replaced by 33 1 311. (0 492 107)
3 = Washer
NOTE: (Disc) Replaced by 33 1 311. (0 492 107)
4 = Washer
NOTE: (Disc) Replaced by 33 1 311. (0 492 107)
5 = Synchronising key
NOTE: (Thrust piece (old)) Discontinued, only available via complete tool
6 = Synchronising key
7 = Synchronising key
NOTE: Not available individually. Only via complete tool set
8 = Synchronising key
9 = Synchronising key
NOTE: For rear axle differential and for installing the camshaft sprocket on the crankshaft (M70) Discontinued, only available via complete tool
1 = Washer
NOTE: (Disc) Discontinued, only available via complete tool
2 = Synchronising key
NOTE: For pulling the bearing inner race off the drive flange - Series: E36/5 Discontinued, only available via complete tool
FITTING AID
Fitting aid Mechanical tool
NOTE: (Installation spoon) For installing the gaiter on the output shafts with sliding joints
BMW X3 Service & Repair Manual > Electronic components: Replacing a rear pulse generator
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE
(ESD protection).
Necessary preliminary work:
Remove rear WHEEL .
Read and comply with GENERAL INFORMATION.
Open housing cover (1).
Disconnect plug connection for pulse generator.
Unclip line fr ...