BMW X3 Service & Repair Manual: Mandrel

Mandrel Mechanical tool

NOTE: (Drift) For driving in the retainer on the rear axle shaft

Storage Location

X8

Mandrel Mechanical tool

NOTE: (Guide mandrel) For fitting differential gear shaft into rear axle final drive

Storage Location

X4

Mandrel Mechanical tool

Replaced by: 83300492338

NOTE: (Drift) For radial seal on output flange - Replaced by 33 3 420. (0 492 338)

Mechanical Mandrel Minimum set: Mechanical tools 335080 tool

NOTE: For driving in shaft seal on drive shaft.

Storage Location

A16

SI number

01 21 06 (300)

Mandrel Mechanical tool

NOTE: (Drive-out mandrel) For the rear axle shaft/Replaced by 33 2 116. (0 492 175) and 33 4 200. (0 492 436)

Mandrel Mechanical tool

NOTE: (Drift) For driving in the retainer on the rear axle shaft (wheel bearing) and on the drive flange of the rear axle final drive (final drive types K and M)

Storage Location

A16

SI number

01 03 91 (333)

Mandrel Minimum set: Mechanical tools AM

NOTE: (Drift) For driving radial shaft seal of output shaft into rear axle final drive. Rear axle final drive: 215

Storage Location

B21

C21

SI number

01 01 07 (333)

Mandrel Mechanical tool

NOTE: (Drift) For driving in the radial seal rings in the rear axle final drive at the output flange with flange diameter 35 mm

Storage Location

X7

Mechanical Mandrel Minimum set: Mechanical tools 335130 tool

NOTE: For driving the radial shaft seal of the output shaft into the rear axle final drive.

Rear axle final drive: 188

Storage Location

C21

SI number

01 01 07 (333)

Mandrel Mechanical tool

Replaced by: 83300491891

NOTE: (Drift) Replaced by 31 2 040. (0 491 891)

Mandrel Minimum set: Mechanical tools Mechanical tool

NOTE: (Drift) For driving radial shaft seal onto drive flange. Replaced by 33 3 470/0 496 596

Storage Location

B26

SI number

01 09 09 (532)

Mandrel Mechanical tool

Replaced by: 83300492342

NOTE: (Drift) For driving the radial sealing ring into the output flange, flange diameter 43 mm - Replaced by 33 3 460. (0 492 342)

SI number

01 10 90 (288)

Mandrel Mechanical tool

Replaced by: 83300492338

NOTE: (Drift) For fitting the radial sealing ring, right-hand output end/Replaced by 33 3 420. (0 492 338)

Mandrel Mechanical tool

Replaced by: 83300492339

NOTE: (Drift) For driving the radial seal into the output flange with flange diameter 38 mm - Replaced by 33 3 430. (0 492 339)

Mandrel AM

NOTE: Discontinued, can only be ordered using complete tool