BMW X3 Service & Repair Manual: Removing and installing/renewing all spark plugs (N20, N26)

BMW X3 Service & Repair Manual / Electrical / Ignition wires, spark plugs / Removing and installing/renewing all spark plugs (N20, N26)

Special tools required:

  • 12 1 220
  • 12 1 230

Necessary preliminary tasks:

  • Switch off ignition.
  • Remove IGNITION COILS.
  • F20, F21, F22, F23, F30, F31, F32, F33, F34, F35, F36 only:

Remove tension struts.

IMPORTANT: Wear safety goggles.

Oil and dirt particles may get into your eyes!

Clean spark plug slot with compressed air.

1. Remove dirt contamination from the spark plug shaft. The plug shaft must be cleaned with compressed air after the ignition coils have been removed but before the spark plugs have been dismounted. After removing the spark plugs, check the sealing surface again for dirt contamination and if necessary, clean with a damp cloth or again with compressed air.

NOTE: Deposits that are not removed according to instructions may enter the combustion chamber and lead to uncontrolled combustion. Remaining deposits in the area of the spark plug seal can lead to leaks and to the spark plugs coming loose during engine operation.

2. Do not grease/oil thread or use any graphite or copper grease. Adhere to the torque values of the packaging information or regulation.

NOTE: If these instructions are not followed, especially with regard to greasing, this may result in mechanical damage to the spark plug housing/thread.

Spark plugs that are not tightened sufficiently lead to leaks and to the spark plugs coming loose during engine operation.

Unscrew spark plugs with special tool 12 1 220 and extension with min. 8º bend.

Flexible ratchet extensions must always be used. If rigid mounting tools are used, there is a risk of insulator breakages.

NOTE: Also do not use a variable plug connection with locking capability as this also poses a risk of insulator breakages.

Electrical

Attach new spark plug (1) to special tool 12 1 230 .

IMPORTANT: Do not let spark plugs fall into the spark plug shaft. This can lead to a reduction of the electrode gap and so impair the smooth running of the engine, especially in idle mode.

Electrical

Screw spark plug into the plug thread hand-tight with special tool 12 1 230 until it reaches the limit position.

Electrical

Installation note: Tighten spark plugs with torque wrench, special tool 12 1 220 and extension with min. 8º bend.

Flexible ratchet extensions must always be used. If rigid mounting tools are used, there is a risk of insulator breakages.

NOTE: Also do not use a variable plug connection with locking capability as this also poses a risk of insulator breakages.

Observe tightening torque.

Electrical

    Remove and install/replace all spark plugs (N52T)
    Special tools required: 12 1 171 Necessary preliminary tasks: Switch off ignition. Remove IGNITION COILS. IMPORTANT: Wear safety ...

    Removing and installing/renewing all spark plugs (N55)
    Special tools required: 12 1 220 12 1 230 Necessary preliminary tasks: Switch off ignition. Remove IGNITION COILS. IMPORTANT: W ...

    Other materials:

    BMW X3 Owners Manual > Automatic climate control with enhanced features: Switching the system on/off
    Switch off Press and hold the left button until the control switches off. Switching on Press any button except: SYNC program. Rear window defroster. Left side of Air volume button. Seat heating. Microfilter/activated-charcoal filter In external and recirculated air mode the micr ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2024 Copyright www.bmwx3tech.com - 0.0111