BMW X3 Service & Repair Manual: Coding control module (dme/dde)

Switch on ignition.

Connect MoDiC or DIS/GT1 Tester.

Select "Coding" program.

For subsequent procedure, follow instructions in MoDiC or DIS/GT1 Tester.

Carry out adjustment of following control units:

  • EWS (electronic immobilizer)
  • DME (Digital Motor Electronics) or
  • DDE (Digital Diesel Electronics)

Refer to "Diagnosis and Coding" service information bulletins on subject of coding.

PROGRAMMING CONTROL UNIT (DME/DDE)

Switch on ignition.

Connect MoDiC or DIS/GT1 Tester.

Select "Programming".

For subsequent procedure, follow instructions in MoDiC or DIS/GT1 Tester.

Carry out adjustment of following control units:

  • EWS (electronic immobilizer)
  • DME (Digital Motor Electronics) or
  • DDE (Digital Diesel Electronics)

Refer to "Diagnosis and Coding" service information bulletins on subject of programming.

    Electronic switching or control units
    ...

    Removing/replacing knock sensor (1st and 2nd cylinder) (N20, N26)
    Necessary preliminary tasks: Read out the fault memory of the DME control unit. Switch off ignition. Remove THROTTLE VALVE ASSEMBLY . Unloc ...

    Other materials:

    BMW X3 Service & Repair Manual > Suspension: Pump and oil supply
    INSTRUCTIONS FOR REMOVING AND INSTALLING EAR CLIPS Special tools required: 32 1 260 NOTE: The work steps are show on assorted components. Ear clip must always be replaced. To remove an ear clip, place special tool 32 1 260 at right angles to ear and cut ear open. The ear clip can be f ...

    BMW X3 Owners Manual

    BMW X3 Service & Repair Manual

    © 2017-2024 Copyright www.bmwx3tech.com - 0.0295