Necessary preliminary tasks:
Unlock connector (1) and remove.
Release bolt (2) on knock sensor.
Remove knock sensor for 1st and 2nd cylinder.
Installation note:
Clean contact surface of knock sensors on engine block.
NOTE: Reassemble the vehicle.
Check stored fault message.
Delete fault memory.
BMW X3 Service & Repair Manual > Final drive mounting: Replace the rubber mounts for the front of the rear axle final drive
suspension
Special tools required:
33 5 200
33 5 206
33 5 166
33 5 163
33 5 162
33 5 161
33 4 466
33 4 465
33 5 105
33 5 164
33 5 165
Necessary preliminary tasks:
Remove exhaust system .
Remove PROPELLER SHAFT AT FINAL DRIVE .
Position special tool 33 5 200 on workshop jack ...