IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .
Necessary preliminary work:
Release screw (1).
Release holder (2) from cylinder head.
Release connector (1) and remove.
Release screw.
Installation note:
Replace screw.
Remove pulse sensor (2).
Installation note:
Replace gasket.
NOTE: Check stored fault messages.
Delete fault memory.
BMW X3 Service & Repair Manual > Control arms and struts: Replacing an upper wishbone
IMPORTANT:
The wishbone must be installed with the opening (U-section) facing downward!
If the wishbone is bent, the screw connection between the control arm and wheel carrier
must be replaced.
Necessary preliminary work:
Remove REAR WHEEL .
Release left and right scr ...